• Bindings
• Accessories
• Schwag
• Dealers & Demos
• Team 22
• Tech Info
• About Us
• FAQ
• Contact

HammerHead & BombShell

Replacing the Cable Spreader

Tools needed: 1/8" allen wrench, medium flat-head screwdriver, channel-lock pliers.

First, unscrew the coils from the heel tube.

Unscrew the machine screw in the spreader with an 1/8" allen wrench.

Pull the coils apart to pop out the inside spreader.

Slide a medium size flat-head screwdriver into the outside spreader. Use a screwdriver that won't open it more than necessary when vertical. Of course it doesn't matter if you're throwing this one out, but you want to find a blade that's not too big to use for the new spreader. The optimum blade width is 9/32", or just over 1/4". The blade will need to be at least this wide.

Twist to open up the spreader.

Slide the coils to the middle and pull the spreader off.

Reverse the directions to install the new spreader. You'll want to use channel-lock pliers to squeeze the orange inside spreader into the outside spreader before installing the screw and nut:

TwentyTwo Designs     |     335 N. 5th East     |     Driggs, ID     |     83422
Toll Free: 1-866-733-0553     |     Phone: 1-208-354-0553     |     Fax: 1-208-354-0554
info@twentytwodesigns.com     |     www.twentytwodesigns.com